12" folded horn.

wikid cheers

iv jst realised what an idiot i have been and jst noticed that the punisher horn on this site is for a 12" driver

yes but punisher needs a particular driver, ciare sw12.00

it would sill work with a different driver wouldnt it???

on annother point what does the qts of a speaker mean?? as in is higher better??

thanks

hfisher22 wrote: it would sill work with a different driver wouldnt it???

Depends on driver, this is a good reason to sim this cab, just IMHO but delta12 can't work good.

hfisher22 wrote: on annother point what does the qts of a speaker mean?? as in is higher better??

depends on the cab, and not only because of this parameter. There's a lot of things to consider.

To me your driver can work good in a mid horn, but for the range of frequencies that you need to cover, a medium throw horn at least (to me 1 m it's the maximum) with a rear chamber of about 40-50 liters should be nice. But can't drop so low, even a port assisted horn should be a solution.
However the beyma plan should be a solution too, it drops so low and is pretty simple to build.

kk kool cheers

check the mth30, bigger than beyma but the top end is lower.

and the driver is very cheap!

111€ @ thomann.de

does any one know of the width and depth of the bill woods design on page 1? or what size would you make it if you were to build?